Reinstall the belt cover using the mounting bolts. Reinstall the bolts in the red chute support bracket. Push the control rod back into the 4-way control rod receiver and line up the support bracket with the mounting holes. Reinstall the muffler shroud mounting bolts. Slide the wire control cables into the retainer clip and position the muffler shroud on the engine. Reinstall the 2 acorn nuts to secure the engine shroud to the engine. Slide the breather hose over the rocker cover fitting and secure the hose with the clamp. Make sure that the breather hose passes through the opening and lines up with the rocker cover breather hose fitting. Reconnect the primer hose to the carburetor.Īlign the choke knob shaft and the 2 carburetor mounting posts with the openings on the engine shroud and work the engine shroud onto the engine. Release the wire control cables from the retainer clip and pull off the muffler shroud. Remove the front muffler shroud mounting bolts. Remove the bolts from the red chute support bracket and pull the support bracket forward, releasing the control rod from the 4-way control rod receiver. Remove the belt cover mounting bolts and pull off the belt cover. Loosen it by tapping it counterclockwise with a hammer and pin punch. Pull off the muffler shroud before reinstalling the engine shroud. Step 1b: If the muffler screws directly into the engine, apply penetrating oil to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |